Alexor PC9155D-433 Przewodnik Instalacji Pobierz pdf (Strona 76)

PC9155 Wireless Alarm Panel

6-3

[][2] Troubles

• Power up system

• Enter [][2] to view Troubles

•Perform actions indicated in the tables below

[][2] Trouble Summary

Trouble [0] GPRS/Ethernet Module Trouble

Trouble [1] Service Required - Press [1] for more information

Low Battery

General System Trouble

General System Tamper

Trouble [2] AC Trouble

Trouble [3] Telephone Line Trouble

Trouble [4] Failure to Communicate

Trouble [5] Device Fault - Press [5] for more information

Trouble [6] Device Tamper - Press [6] for more information

Trouble [7] Wireless Device Low Battery - Press [7] for more information

Trouble [8] Loss of Time or Date

Trouble Cause Troubleshooting

Trouble [0] GPRS/Ethernet Module Trouble Press [<][>] to determine specific trouble

Alternate Comm SIM Lock

The SIM lock feature has been enabled

and the unit has not been programmed

with the correct PIN for the SIM card.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

GPRS/Ethernet Module

Trouble

This condition is created when the

GPRS/Ethernet module has detected a

radio or SIM failure, a GPRS network

trouble, or insufficient signal strength.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

Alternate Comm GSM

Trouble

This condition is created when the

GPRS/Ethernet module has detected a

network absent condition.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

Alternate Comm Receiver

Trouble

This condition is generated when the

GPRS/Ethernet module loses

supervision or fails to initialize a receiver.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

Alternate Comm Fault

This condition is created when the

PC9155 loses communication with an

Ethernet or GPRS module on the

system.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

Alternate Comm Config

SMS Trouble

This condition is created when the

GPRS/Ethernet module detects a

Connect 24 Configuration SMS failure

trouble.

• Please refer to the TL260GS/TL265GS/GS2060/GS2065

Installation Manual for more details.

Trouble [1] Service Required Press [1] to determine specific trouble

Low Battery

Main panel battery less than 11.4V

+/- 0.1V.

NOTE: This trouble condition will not

clear until the battery voltage is 12.5V

+/- 0.1V.

NOTE: If battery is new allow 24 hrs. for battery to charge.

• Verify voltage measured across AC terminals is 16-18 VAC.

• Verify voltage measured across battery terminals is 12.5V +/- 0.1V.

• Replace transformer if required.

• Disconnect then reconnect battery leads.

General System Trouble

The system has detected the presence

of a RF Jam for 20 seconds or

communications with the wireless

receiver have failed causing a hardware

fault.

Check Event Buffer to determine specific trouble.

If buffer logs RF Jam trouble: check for external 433MHZ signal sources.

To disable RF Jam, enable option [7] in program section [804]

subsection [900].

• If buffer logs ‘Hardware Fault’ - replace panel.

General System Tamper

Cover tamper tripped. • Verify that tamper buttons are installed into backplate and front-

plate, and that the frontplate is fully in place.

• Verify that the panel is properly secured to the wall with the front

cover on.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 87 88

Komentarze do niniejszej Instrukcji

Brak uwag

Alexor PC9155D-433 Przewodnik Instalacji Strona 76

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Alexor PC9155D-433